Enters: bcdedit.exe /set nointegritychecks ON.Unlike the previous one, it only requires the introduction of a command. There is another option of action through "Command line". Signature verification activated again.To reactivate it, type: bcdedit -set loadoptions ENABLE_INTEGRITY_CHECKS.After the information that indicates the successful completion of the task, type that expression: bcdedit.exe -set TESTSIGNING ON.Activated by "Command line".in which you must enter the following: bcdedit.exe -set loadoptions DDISABLE_INTEGRITY_CHECKS.By right-clicking on the specified item ( PCM), select the position "Execute as an administrator". In the directory that opens, look for Command Prompt.
But in the vast majority of cases you must apply exactly the above option. In some cases it may be a button or a different combination, depending on the BIOS version installed on your PC. As soon as the start-up beep sounds, press the key. Restart or turn on the computer, depending on its current state.To disable signature verification of drivers when installing them in Windows 7, you can boot the operating system in a special mode. Method 1: Switch to boot mode with disabling mandatory signature verification In these cases, it is a good idea to use the methods described below. Therefore, we do not recommend disabling protection when installing objects downloaded from the Internet, as it is very risky.Īt the same time, there are situations where the authenticity of the drivers is certain (for example, when they are shipped with the computer on disk media), but they lack a digital signature for some reason. The point is that unknown drivers can be a source of vulnerability or direct danger if they are a product developed by intruders. It must be said from the outset that disabling digital signature verification is at your own risk. 2.1 Method 1: Switch to boot mode with disabling mandatory signature verification.
0 kommentar(er)
